SCROLL DOWN
TO EXPLORE MORE
Author: Cmiri
Rating: 5
Review: I replaced the stock fans of a Corsair H150i Pro for 3x BeQuiet! Silent Wings 3 (high speed model). The Corsair fan controller is meant to be for lower RPM fans and l'm guessing that's why it fails to control the SW3 fans properly. That's where this EK cable splitter comes in and it does the job as intended. I plugged all 3 fans to the cable splitter and then the PWM end to the motherboard chassis fan plug. I can now control these fans at will via Asus BIOS (Fan Xpert and l are not in good terms). Other than that, l'm always 'highly' reluctant to buy a product sold by a 3rt party company (a.k.a Amazon Marketplace). In this case, the seller is "CCL Computers" and all l can say is l had a fantastic experience (i.e. right item, factory sealed and super fast shipment). Thanks "CCL Computers." *Just to clarify: the cable splitter consists of one 'PWM' end (4 pins) which you connect to the motherboard and 3 separated cables where you connect your fans. Of these 3 cables, 1 has 4 pins and the other 2 have only 3. However, all the 3 fans connected to the cable follow the 'PWM' signal sent by the motherboard. You could plug 3 pins/non 'PWM' fans to the cable splitter but, of course, l assume all 3 fans connected would run at full speed (unless your motherboard 'DC' mode may be able to still control them).
